Introduce the cleaning method of automatic labeling machine

Labeling machine

Automatic labeling machine cleaning method introduction 

   Automatic labeling machine is suitable for flat, square, round and tapered products in the daily chemical, food, dairy, pharmaceutical and other light industry, single and double-sided multi-functional automatic labeling, PLC and servo labeling system, multi-functional human-machine interface, production counting, parameter adjustment and other visual monitoring, with rich help function and fault display function; the overall material of the equipment is international standard S304 Stainless steel and imported aluminum alloy, double-layer anodic oxidation treatment, never rust and deformation.

   Automatic labeling machine cleaning method introduction

Automatic labeling machine should pay attention to regular cleaning, which is a great help to the stable operation of the equipment later, and cleaning work seems simple, but there are a lot of instructions, especially the cleaning order, the next small introduction for you.

1, remove the standard plate, glue funnel, glue bucket, blowing tube, protective door, placed in the immersion car dip, (water temperature 400 ℃ -500 ℃, but the standard plate must be placed separately, shall not use more than 40 ℃ of water immersion).

2, with alkaline detergent water with a damp cloth to cover the surface of the labeling table and more glue.

3、Wash the big turntable, bottle tray, label sweep, label table, column gate, machine top, bottle dividing board, star wheel, guard and platform with hair sweep or cloth with alkaline cleaner water.

4、Wash the residual glue of the label box, label drum, labeling clip and labeling pad with wet cloth.

5、Wash the surface of the label drum with a wet cloth, and rinse with water and direct immersion are strictly prohibited.

In addition, in use, if the automatic labeling machine encountered the following problems, users can refer to the following methods to solve.

1, label split: label through the die-cutting made after the finished product, usually the backing paper will be left wider, the main purpose of this is for the user in use can better uncover the label. And in the process of handling or transportation, these extra edge part will be knocked crack, resulting in small cracks. There is also a part of the reason is that the labeling machine in the process of automatic labeling, itself has a certain tension, in this tension is also very pull off the label.

2, poor die-cutting: the quality of die-cutting has a very deep impact on whether the label is torn. If the pressure of the die-cutting is too large will cause the bottom paper to break the tape, usually due to the tearing brought about by die-cutting, the position of the die-cutting line at the split will be relatively neat.

3, glue seepage: glue seepage in addition to the demon is due to label rewinding too tight, the glue out of the undried.